10 Inch 250MM High Capacity Linear Actuator with Hall Effect Sensor for Synchronized Control (Model 0041605-1)

10 Inch 250MM High Capacity Linear Actuator with Hall Effect Sensor for Synchronized Control (Model 0041605-1)This is a 250mm stroke high performance linear actuator with a built in Hall effect sensor, designed for heavy lifting operations, providing ultra high push pull forces of up to 2,700 lbs (12,000 N). It features a manual override, allowing users to extend and retract the actuator's telescopic rod using hand tools even in the event of a power outage. It is widely used in doors, windows, cellars, trapdoors, hatchways, solar tracking system, medical

2) The operation by the slide potentiometer:

up to 6000 N / 600 kg / 1300 lbs at 3

3) Push the handle backward

Two-Way Working Mode with Feedback Function:The transmitter and the receiver have a Two-way working mode

Output Voltage: 12~30 VDC same as input voltage

Install the flat plate bracket to the bottom of linear actuator A and tighten the three screws with a hexagonal wrench

Stroke and Length (Model 0041516) Parameter Value Stroke 500mm Retraction Length 675mm (center distance between two mounting holes when the linear actuator is fully retracted) Extension Length 1175mm (center distance between two mounting holes when the linear actuator is fully extended) The linear actuator has two built-in limit switches

Release the left button ▲: Motor 1 or linear actuator 1 stops

Especially when the DC motor is in a place without a network

Install the flat base to the bottom of linear actuator A and tighten the three screws with a hexagonal wrench

2) Press the learning button on the receiver module for 1-2 seconds

This extension cable is 5 meters long