Hall Effect Sensor For High Performance Linear Actuator F 12000N (Model 0043020)

Hall Effect Sensor For High Performance Linear Actuator F 12000N (Model 0043020)Hall Effect Sensor For Electric Linear Actuator F If you want to use a synchronous controller to operate 2 or 4 linear actuators fully synchronously, you will need to add built in Hall effect sensors to each linear actuator. If you purchased Hall effect sensor along with linear actuator, we will install Hall effect sensor to linear actuator for you. When 2 or 4 linear actuators are running together, Hall sensor will send Hall signals to the

1 x Receiver: S2PFS-DC12 / S2PFS-DC24

please contact us when placing the order and pay an additional 20% of the order amount as prepaid duties

This is a micro industrial electric linear actuator with a 200mm stroke

can be used for 12 months) Standby Current 4uA Operating Current 14mA Operating Frequency 433Mhz Transmitting Distance 500m / 1500ft (theoretically) If you stretches the telescopic antenna

5) Press the button K1

How to adjust the speed of two motors or linear actuators by the knobs:

The above data is the maximum load capacity that can be obtained when the linear actuator runs in the vertical direction

When you press and hold a manual switch

The operation of Interlocking mode with the transmitter CC-2:

then press the button K2 or K3 to adjust this delay time A

Cell Number: 6

all linear actuators extend outward at the same time