4 In 100MM Adjustable Stroke Industrial Linear Actuator with NC Magnetic Reed Switch (Model 0041512-4)

4 In 100MM Adjustable Stroke Industrial Linear Actuator with NC Magnetic Reed Switch (Model 0041512-4)This is an adjustable stroke industrial linear actuator with a standard stroke of 100mm. It is equipped with two external normally closed magnetic switches that can slide freely. By adjusting the positions of these two normally closed magnetic switches, the linear actuator can be controlled to work within the set stroke length. For example, for a linear actuator with a stroke of 100mm, you can set it to move within a stroke range of 30mm to 80mm. Key

This receiver only works with 5000m transmitters

Stroke and Length (Model 0041555) Parameter Value Stroke 450mm Retraction Length 700mm (center distance between two mounting holes when the linear actuator is fully retracted) Extension Length 1150mm (center distance between two mounting holes when the linear actuator is fully extended) The linear actuator has two built-in limit switches

if another limit switch is activated

Press the button ▼ again: DC motor or linear actuator stops

a specified stroke of 7 mm is less than the standard stroke of the ordered actuator (10 mm)

1) Setting Self-locking mode: Turn on the third bit of the dip switch

If you want to control DC linear actuator or small bi-directional DC motor (two control lines)

you can also choose to retain the original standard retraction length of 580 mm

resulting in a retraction length of 335 mm

you can also reset by connecting the RST and COM terminals on the controller

Use an 8-bit microprocessor designed and developed with low-power and high-speed CMOS technology

two limit switches and the two diodes to the manual switch